The MAX14820 transceiver is suitable for IO-Link® devices and 24V binary sensors/actuators. All specified IO-Link data rates are supported. In IO-Link applications, the transceiver acts as the physical layer interface to a microcontroller running the data-link layer protocol. Additional 24V digital inputs and outputs are provided. Two internal linear regulators generate common sensor and actuator power requirements: 5V and 3.3V.

On-board C/Q and DO drivers are independently configurable for push-pull, high-side (PNP), or low-side (NPN) operation. The device detects the IO-Link C/Q wake-up condition and generates a wake-up signal on the active-low WU output. The C/Q and DI inputs have selectable current loads for use in actuators.

An SPI™ interface allows configuration and monitoring of the devices. Extensive alarm conditions are detected and communicated through the active-low IRQ output and the SPI interface. The devices feature reverse-polarity, short-circuit, and thermal protection. All power lines are monitored for undervoltage conditions.

The C/Q driver is specified for sinking/sourcing ±300mA. The DO driver is specified for sinking/sourcing ±135mA.

The MAX14820 is available in a 4mm x 4mm, 24-pin TQFN package, and is specified over the extended -40°C to +85°C temperature range.

• MAX5974B - 有源钳位、扩频、电流模式PWM控制器
• MAX3008 - +1.2V至+5.5V、±15kV ESD保护、0.1µA、35Mbps、8通道电平转换器
• MAX11125 - 1Msps、低功耗、12/10/8位、4/8/16通道串行ADC
• MAX6398 - 过压保护开关/限幅控制器，可工作至72V
• MAX6801 - 3引脚、低功耗微处理器复位电路
• MAX1316 - 8/4/2通道、14位、同时采样ADC，提供±10V、±5V或0至+5V模拟输入范围
• 71M6542GT - 电表IC
• MAX6167 - 高精度、微功耗、低压差、高输出电流、SO-8封装电压基准
• MAX5142 - +3V/+5V、串行输入、电压输出、14位DAC
• MAX6009B - 1µA、SOT23封装、高精度并联型电压基准